Note: The ARC must be configured to use SIA and SIA Extended 1 or 2. If such a failure occurs, a SIA event is sent to ARC1. The following options combine the Enabled option with hardware-fault reporting in the event of a main microprocessor failure. Enabled Inverted - Output 6 is normally ON but is turned OFF when a watchdog fault occurs.Pulsed - Output 6 is PULSED at 100ms intervals.Enabled - Output 6 is normally OFF but is turned ON when a watchdog fault occurs.Disable - Output 6 is available as a general purpose output.The following modes of operation of the watchdog output can be selected: If enabled, then the internal and external bells (system and area), the keypad buzzers and annunciation messages on the Comfort Keypad will be silenced during audio verification.Įnables output 6 on the SPC controller board to be used for monitoring purposes.
If enabled, the LED behavior of readers will be controlled by the panel. If a ‘Fail to Communicate‘ alert is raised, external bells will activate.
ZONEALARM SECURITY UPDATE OVERDUE ERROR FULL
If selected, the following are not deactivated in Full Engineer mode: If enabled, the panel will always report alarm activations and panic alarms. If enabled, audio expander will not turn on LED when microphone active. If enabled, key fob is enabled to restore alerts by pressing the Unset key. The user must call the installer to generate a restore code, with which the user is able to restore the alarm.Įnable this for offline expander zones to generate a zone tamper. On resetting an alarm, a 6 digit code is required. Grade 3 only: A user, who does not have the right to restore an alarm, is able to restore the alarm with this feature. Note: This option is displayed for the Domestic and Commercial installation types, only. Select to enable multiple areas on the system. The options displayed vary depending on the Security Grade of the system. Configure the fields as described in the table below.Select Configuration > System > System Options.
0 kommentar(er)
